JMP is excited to announce our new technical HVAC magazine! It is a great resource to get bite-sized educational pieces similar to the content featured in our seminars. Register to have the latest blog sent to your email address.
In our last blog we discussed heat exchanger piping on the cooling tower/condenser water side of a system with integrated waterside economizing to meet ASHRAE 90.1. Today, we’re going to tackle the chilled water…
Read MoreWaterside economizing relies on cold water from the cooling tower (aka condenser water) to absorb some or all of the heat from inside the building. In typical waterside economizing applications, plate & frame heat exchangers are used to…
Read MoreHold the phone; we’re about to blow your mind.
Did you know it can take a larger cooling tower to perform the same amount of cooling when it’s cold outside than when it’s hot?
Read More
Has your state adopted ASHRAE 90.1-2010 or beyond into its commercial building code? If so, then it is highly likely that you should be incorporating either waterside or airside economizing into your cooling design. The Standard has effectively made air or waterside economizing a requirement in virtually every…
Read MoreIn our last blog, we determined that we required a 56 PSI pressure boost in our 100 Room Apartment example. Previous to that we determined (using the Hunters Curve) that we had a maximum total demand of 180 gpm. With these two values we are now prepared to select…
Read More
Visit our Contact Page and let us know what information you'd like to receive.
Powered by Squarespace
