JMP is excited to announce our new technical HVAC magazine! It is a great resource to get bite-sized educational pieces similar to the content featured in our seminars. Register to have the latest blog sent to your email address.
The last several weeks we've focused on steam and condensate handling. Today we'll talk about steam flash tanks. Condensate flashes into steam in the return lines after the steam traps. When the steam pressure exceeds 15 PSIG and is defined as medium or high pressure, flash tanks are used to...
Read MoreLast week we talked about the critical relationship between the steam condensate return temperature and proper pump NPSHR. This week we'll look at the role the discharge balance plays in assuring....
Read MoreOne challenge to selecting a steam condensate return unit is the return temperature of the condensate after leaving the steam heat exchanger. This week we'll offer some suggestions to assist the engineer or designer...
Read MoreHopefully, the message from our last blog on Steam Basics was clear: Don’t lift the condensate out of a steam heat exchanger or coil with a modulating control valve. So what do we do if a gravity return main is not located below the steam trap? We use a ..
Read MoreDon’t lift the condensate out of a steam heat exchanger or coil with a modulating control valve! Over the last several weeks we have made this declaration several times. Once again, a voice in the wilderness has cried out....
Read More
Visit our Contact Page and let us know what information you'd like to receive.
Powered by Squarespace
