Heads up on ASHRAE 90.1 - 2013 and Its Impact on Commercial HVAC Design!

The Department of Energy (DOE) released a statement last month saying that ANSI/ASHRAE/IES Standard 90.1 - 2010 Energy Standard for Buildings Except Low-Rise Residential Buildings offers 8.5% source energy savings and 7.6% site energy savings over the 2010 version. That’s enough to warrant another round of changes to commercial building codes. State governments now officially have until September 26, 2016....
Read More

Domestic Hot Water Recirculation Part 2: Where ASHRAE 90.1 Conflicts with OSHA

When it comes to domestic hot water recirculation design, OSHA safety provisions and ASHRAE 90.1 energy efficiency requirements have put plumbing engineers between the proverbial rock and hard place. In an effort to minimize the energy penalty associated with mandatory domestic hot water recirculation, ASHRAE 90.1 has created operational parameters for these systems. The problem is that these parameters are in direct conflict with OSHA’s requirements for Legionella prevention.
Read More

What is Legionella and Why Should You Care?

Legionella. It is a potentially fatal bacterium that for the most part has managed to fly under the radar of the general public since it was first determined as the cause of Legionnaires’ disease in the 1970s. Despite the fact that there are well-known techniques to prevent the growth of the causative bacteria, legionellosis (commonly known as Legionnaires’ disease) has taken the lives of well over 100,000 people in the U.S. alone. Furthermore, reported cases of the bacteria has risen 217 percent in just the last decade, according to the Centers for Disease Control and Prevention.
Read More

No More Constant Speed Pressure Boosting Under ASHRAE 90.1 - 2010

By Mark Bingham

“Constant speed pressure boosters are DEAD and GONE TO HEAVEN!”

That was the prevailing message recently from Chris Edmondson, CEO of JMP, as he briefed the folks here at about the upcoming mandatory changes under SECTION 10.4 of the new ASHRAE 90.1 – 2010.

Read More

Federal Buildings To Comply with ASHRAE 90.1-2010 – Just Like the Rest of Us!

By Chad Edmondson

It’s only a matter of weeks before new commercial buildings codes must comply (or state’s must a request for extension) with ASHRAE 90.1 -2010, as we reported in an earlier blog.  And it looks like federal buildings will also have to follow suit too – albeit a little later

Read More