JMP is excited to announce our new technical HVAC magazine! It is a great resource to get bite-sized educational pieces similar to the content featured in our seminars. Register to have the latest blog sent to your email address.
Waterside economizing relies on cold water from the cooling tower (aka condenser water) to absorb some or all of the heat from inside the building. In typical waterside economizing applications, plate & frame heat exchangers are used to…
Read MoreHold the phone; we’re about to blow your mind.
Did you know it can take a larger cooling tower to perform the same amount of cooling when it’s cold outside than when it’s hot?
Read More
Has your state adopted ASHRAE 90.1-2010 or beyond into its commercial building code? If so, then it is highly likely that you should be incorporating either waterside or airside economizing into your cooling design. The Standard has effectively made air or waterside economizing a requirement in virtually every…
Read MoreWhen designing cooling tower suction piping, it is absolutely critical that engineers have sufficient NPSH to the condenser water pump and avoid any piping design errors that could cause air to come out of the pumping solution. If either of these becomes a problem…
Read MoreSo far in this series, you’ve learned how to incorporate all of the essential data into your cooling tower life cycle analysis -- everything from operational hours at part load conditions to suggested outdoor wet bulb design points. You’ve done most of the heavy lifting. Now it is up to the vendor to…
Read More
Visit our Contact Page and let us know what information you'd like to receive.
Powered by Squarespace
